High Precision Square & Round & Right Angle Flange Output Gearbox with Servo Motor

• Transport Package: Carton
• Specification: 60mm
• Trademark: GPG
• Origin: China
• Model NO.: GBE
• HS Code: 8501510090
• Production Capacity: 50000PCS/Month

Product Description

Planetary Gearbox
GBF	060	10	S1	P1
Reducer Series Code	Size	Gear Ratio	Output Shaft Type	Reducer Backlash
GBF - High-Precision Square Flange Output	45mm  60mm 90mm  115mm  142mm 180mm	1 Stage: 3   4   5   6  7  8  9 10 2 Stage: 12  15  16  20  25  28  30  35  40  45 60  70  80  90  100	S1 - Smooth Output Shaft S2 - Output Shaft With Key	P1 - Reduced Backlash P2 - Standard Backlash

Series	Unit	GBF						Z^(2)
Lifetime	%	20000
The efficiency with Full Load^(3)	°C	97						1
		94						2
0perating Temp^(4)		-25~+90
Degree of Protection		IP65
Lubrication		Lifetime Lubrication
Mounting Position		Any
Motor Flange		DIN 42955-N
Item	Unit	GBE045	GBE060	GBE090	GBE115	GBE142	GBE1180	Z^(2)
P1 Low Backlash P1	arcmin	≤5	≤3					1
		≤7	≤5					2
P2 Standard Backlash P2	arcmin	≤7	≤5					1
		≤9	≤7					2
Nominal Input Speed^(8)	rpm	4000	3000
Maximum Input Speed^(8)	rpm	8000	6000
Maximum Radial Load ^(5)(6)(9)	N	710	1200	2400	4300	9100	15000
Maximum Axial Load ^(5)(6)(9)		640	1100	2200	3900	8200	14000
Torsional Stiffness	Nm/arcmin	3	7	14	25	50	145	1
		4	8	16	28	55	155	2
Weight	Kg	0.4	1.2	2.9	6.8	14.2	22	1
		0.6	1.4	3.6	8.7	17.1	28	2
Running noise ^(7)	dB(A)	56	58	6	63	65	67

(1) Ratios(=n in/n out)
(2) Number of stages
(3) Depends on the ratio, n2=100rpm
(4) Referring to the middle of the body surface
(5) These values refer to a speed of the output shaft of n2=100rpm on duty cycle KA=1
     and S1-mode for electrical machines and T= 30°C
(6) Halfway along the output shaft
(7) Sound pressure level; distance 1m; measured on idle running with an input speed of ni =3000rpm; i=5
(8) Allowed operating temperature must be kept; other input speeds on inquiry
(9) Depending on the required output torque, radial and axial loads, cycle, and required storage life,                   
     deviating or partly higher values are possible.
We recommend carrying out accurate dimensioning with GPG or to consult Neugart in this respect.